Multicast Commands 1081
Syntax
ip pim sparse
no ip pim sparse
Default Configuration
PIM not enabled by default.
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router.
Example
console(config)#ip pim sparse
ip pim ssm
Use the ip pim ssm command in Global Configuration mode to
administratively configure PIM source specific multicast range of addresses
for IP multicast routing. Use the no form of this command to remove
configured ranges of addresses from the router.
Syntax
ip pim ssm {default |
group-address group-mask
}
no ip pim ssm {default |
group-address group-mask
}
Parameter Description
Parameter Description
default Defines the SSM range access list to 232/8.
group-address An IP multicast group address.
group-mask An IPv4 mask in a.b.c.d form where a, b, c and d range from 0-
255.
2CSPC4.XCT-SWUM2XX1.book Page 1081 Monday, October 3, 2011 11:05 AM