LLDP Commands 583
Parameter Ranges
Not applicable
Command Mode
Interface (Ethernet) Configuration
Default Value
By default, notifications are disabled on all supported interfaces.
Usage Guidelines
No specific guidelines.
Example
console(config)#lldp med confignotification
lldp med faststartrepeatcount
This command is used to set the value of the fast start repeat count.
Syntax Description
lldp med faststartrepeatcount
count
no lldp med faststartrepeatcount
•
count
— Number of LLDPPDUs that are transmitted when the protocol is
enabled. (Range 1–10)
Command Mode
Global Configuration
Default Value
3
Usage Guidelines
No specific guidelines.
2CSPC4.XCT-SWUM2XX1.book Page 583 Monday, October 3, 2011 11:05 AM