1118 OSPF Commands
Default Configuration
1 second is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 40-second transmit-delay interval.
console(config-router)#area 10 virtual-link
192.168.2.2 transmit-delay 40
auto-cost
By default, OSPF computes the link cost of each interface from the interface
bandwidth. The link cost is computed as the ratio of a “reference bandwidth”
to the interface bandwidth (ref_bw / interface bandwidth), where interface
bandwidth is defined by the “bandwidth” command. Because the default
reference ban dwidth is 1 00 Mbps, O SPF uses the same default link cost for all
interfaces whose bandwidth is 100 Mbps or greater. To change the reference
bandwidth, use the auto-cost command, specifying the reference bandwidth
in megabits per second. The different reference bandwidth can be
independently configured for OSPFv2 and OSPFv3.
Syntax
auto-cost reference-bandwidth
ref_bw
•
ref_bw
— The reference bandwidth in Mbps (Range: 1–4294967).
Default Configuration
The default reference bandwidth is 100 Mbps.
Command Mode
OSPFv2 or OSPFv3 Router Configuration mode.
2CSPC4.XCT-SWUM2XX1.book Page 1118 Monday, October 3, 2011 11:05 AM