172 Using the CLI
• <Interface Type> Unit#/Slot#/Port# — Identifies a specific interface by
the interface type tag followed by the Unit# followed by a / symbol, then
the Slot# followed by a / symbol, and then the Port#.
For ex amp le,
gi2/0/10 identifies the gigabit port 10 in slot 0 within the second unit on
a non-blade switch. Table2-4 below lists the supported interface type
tags.
•
Unit
# — The unit number is greater than 1 only in a stacking solution
where a number of switches are stacked to form a virtual switch. In this
case, the Unit# indicates the logical posit ion of the switch in a stack. The
range is 1–12. The unit value is 1 for standalone switches.
•
Slot
# — The slot number is an integer number assig ned to a particular
slot. Front panel ports have a slot number of 0. Rear panel ports are
numbered from 1 and can be identified by the lexan on the rear panel. Use
the
show slot
command on page 1610 to retrieve information for a
particular slot.
•
Port
# — The port number is an integer number assigned to the physical
port on the switch and corresponds to the lexan printed next to the port on
the front or back panel. Ports are numbered from 1 to the maximum
number of ports available on the switch, typically 24 or 48.
Within this document, the tag interface–id refers to an interface identifier
that follows the naming convention above.
2CSPC4.XCT-SWUM2XX1.book Page 172 Monday, October 3, 2011 11:05 AM