VLAN Commands 795
Default Configuration
The default value for the
vlan-id
parameter is 1 when the VLAN is enabled.
Otherwise, the value is 4093.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how to configure the PVID for 1/0/8, when the
interface is in general mode.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#switchport general pvid 234
switchport mode
Use the switchport mode command in Interface Configuration mode to
configure the VLAN membership mode of a port. To reset the mode to the
appropriate default for the switch, use the no form of this command.
Syntax
switchport mode {access | trunk | general}
no switchport mode
Parameter Description
Parameter Description
access An access port connects to a single end station belonging to a
single VLAN. An access port is configured with ingress filtering
enabled and will accept either an untagged frame or a packet
tagged with the access port VLAN. An access port transmits
only untagged packets.
2CSPC4.XCT-SWUM2XX1.book Page 795 Monday, October 3, 2011 11:05 AM