314 Auto-VoIP Commands
Po10 Disabled 6
Po11 Disabled 6
Po12 Disabled 6
Po13 Disabled 6
Po14 Disabled 6
Po15 Disabled 6
--More-- or (q)uit
The following example shows command output when a port is specified:
console#show switchport voice gigabitethernet 1/0/1
Interface Auto VoIP Mode Traffic Class
--------- -------------- -------------
Gi1/0/1 Disabled 6
The command output provides the following information:
•
AutoVoIP Mode
—The Auto VoIP mode on the interface.
•
Traffic Class
—The Cos Queue or Traffic Class to which all VoIP traffic is
mapped. This is not configurable and defaults to the highest COS queue
available in the system for data traffic.
switchport voice detect auto
The switchport voice detect auto command is used to enable the VoIP Profile
on all the interfaces of the switch (global configuration mode) or for a specific
interface (interface configuration mode).Use the no form of the command to
disable the VoIP Profile.
2CSPC4.XCT-SWUM2XX1.book Page 314 Monday, October 3, 2011 11:05 AM