130 Command Groups
OSPF
show ip mcast mroute
group
Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mcast mroute
source
Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
show ip mcast mroute
static
Displays all the static routes configured in the
static mcast table.
PE
show ip pim bsr-router Displays the bootstrap router (BSR)
information.
PE
show ip pim interface Displays PIM interface status parameters. If no
interface is specified, the command displays the
status parameters of all PIM-enabled interfaces.
UE or
PE
show ip pim neighbor Displays PIM neighbors discovered by PIMv2
Hello messages. If no interface is specified, the
command displays the neighbors discovered on
all PIM-enabled interfaces.
UE or
PE
show ip pimrphash Displays the rendezvous point (RP) selected for
the specified group address.
UE or
PE
show ip pim rp mapping Displays the mappings for the PIM group to the
active rendezvous points (RPs).
UE or
PE
a. For the meaning of each Mode abbreviation, see Mode Types on page 79.
Command Description Modea
area default-cost Configures the advertised default cost for the
stub area.
ROSPF
area nssa Configures the specified area ID to function as an
NSSA.
ROSPF
area nssa default-info-
originate
Configures the metric value and type for the
default route advertised into the NSSA.
ROSPF
area nssa no-redistribute Configures the NSSA Area Border router (ABR)
so that learned external routes are not
redistributed to the NSSA.
ROSPF
Command Description Modea
2CSPC4.XCT-SWUM2XX1.book Page 130 Monday, October 3, 2011 11:05 AM