Multicast Commands 1077
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan10)#ip pim hello-interval 20
ip pim join-prune-interval
The ip pim join-prune-interval command in Interface (VLAN)
Configuration mode to administratively configure the frequency of
join/prune messages on the specified interface. Use the no form of this
command to return the configuration to the default. This command
deprecates the ip pimsm message-interval and ip pimsm join-prune-interval
commands.
Syntax
ip pim join-prune-interval
interval
no ip pim join-prune-interval
•
interval
— The number of seconds between successive join-prune
transmissions. Range: 0–18000 seconds. Default is 60.
Default Configuration
The default join/prune interval is 60 seconds.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only has an effect if sparse mode is enabled.
Example
console(if-vlan10)#ip pim join-prune-interval 30
2CSPC4.XCT-SWUM2XX1.book Page 1077 Monday, October 3, 2011 11:05 AM