1080 Multicast Commands
Syntax
ip pim rp-candidate vlan {

vlanid group-address group-mask

[interval

interval
]}
no ip pim rp-candidate vlan

vlanid group-address group-mask}

Parameter Description
Default Configuration
None - the router does not advertise itself as an RP candidate by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip pimsm rp-candidate vlan 10
239.1.0.0 255.255.0.0 interval 30
ip pim sparse
Use the ip pim sparse command in Global Configuration mode to
administratively configure PIM sparse mode for IP multicast routing. Use the
no form of this command to disable PIM sparse mode. This command
replaces the ip pimsm command.
Parameter Description
vlan-id A valid VLAN identifier with multicast routing enabled.
group-address A valid multicast group address.
group-mask A mask indicating the range of multicast groups for which the
router should advertise itself as an RP-candidate.
interval (Optional) Indicates the RP candidate advertisement interval.
The range is from 1 to 16383 seconds. The default value is 60
seconds.
2CSPC4.XCT-SWUM2XX1.book Page 1080 Monday, October 3, 2011 11:05 AM