1448 Power Over Ethernet Commands
Syntax
power inline high-power
no power inline high-power
Default Behavior
The default value is disabled.
Command Mode
Interface Configuration.
User Guidelines
The system does not apply high power to the interface until an LLDP-MED
packet is received from the link partner requesting the application of high
power.
power inline limit
Use the power inline limit command to configure the type of power limit.
Use the no form of this command to set the power limit type to the default.
Syntax
power inline limit {class | none | user-defined
limit
}
no power inline limit
Parameter Description
Parameter Description
Class Allows the port to draw up to advertised class maximum
power.
None Allows port to draw up to class 0 maximum power in low
power mode and class 4 maximum power in high power
mode.
User-defined
limit
Allows the port to draw up to user-defined configured
value. The range of limit is 1000-31200 milliwatts.
2CSPC4.XCT-SWUM2XX1.book Page 1448 Monday, October 3, 2011 11:05 AM