Power Over Ethernet Commands 1447
console(config-if-1/0/1)# power inline auto
power inline detection
Use the power inline detection command in Interface Configuration mode
to configure the detection type that tells which types of PD’s will be detected
and powered by the switch. Use the no form of this command to set the
detection type to the default.
Syntax Description
power inline detection { dot3af | dot3af+legacy | legacy-only }
no power inline detection
Parameter Description
Default Value
Default value is dot3af.
Command Mode
Interface Configuration
User Guidelines
This command has no user guidelines.
power inline high-power
Use this command to configure the port high power mode. Use the no form
of this command to disable high power mode. In high power mode, the
switch (PSE) negotiates the power budget with the powered device (PD) via
LLDP.
Parameter Description
dot3af IEEE 802.3af 4-point detection only.
dot3af+legacy IEEE 802.3af 4-point detection followed by Legacy.
legacy-only Legacy capacitive detection only.
2CSPC4.XCT-SWUM2XX1.book Page 1447 Monday, October 3, 2011 11:05 AM