Dell area virtual-link retransmit-interval

OSPFv3 Commands 1189
Syntax
area areaid virtual-link neighbor hello-interval seconds
no area areaid virtual-link neighbor hello-interval
• areaid — Valid OSPFv3 area identifier.
•
neighbor — Router ID of neighbor.
•
seconds — Hello interval. (Range: 1-65535)
Default Configuration
10 is the default value for seconds .
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a hello interval of 20 seconds for the OSPF
virtual interface on the virtual interface identified by area 1
and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 hello-
interval 20
area virtual-link retransmit-interval
Use the area virtual-link retransmit-inter val command in Router OSPFv3
Configuration mode to configure the retransmit interval for the OSPF virtual
interface on the virtual interface identified by
areaid and neighbor .
Syntax
area areaid virtual-link neighbor retransmit-interval seconds
no area areaid virtual-link neighbor retransmit-interval
• areaid — Valid OSPFv3 area identifier.
2CSPC4.XCT-SWUM2XX1.book Page 1189 Monday, October 3, 2011 11:05 AM