IPv6 PIM Commands 989
49
IPv6 PIM Commands
This chapter explains the following commands:

ipv6 pim

Use the ipv6 pim command to administratively configure PIM mode for IPv6
Multicast routing on a VLAN interface. Use the no form of this command to
disable PIM on the interface.
Syntax
ipv6 pim
no ipv6 pim
Default Configuration
PIM is disabled on interfaces by default.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
There are no user guidelines for this command.
ipv6 pim ipv6 pim join-prune-
interval
show ipv6 pim bsr-router
ipv6 pim sparse (Global
config)
ipv6 pim register-rate-limit show ipv6 pim interface
ipv6 pim dense ipv6 pim rp-address show ipv6 pim neighbor
ipv6 pim bsr-border ipv6 pim rp-candidate show ipv6 pim rp hash
ipv6 pim bsr-candidate ipv6 pim spt-threshold show ipv6 pim rp mapping
ipv6 pim dr-priority ipv6 pim ssm
ipv6 pim hello-interval show ipv6 pimsm
2CSPC4.XCT-SWUM2XX1.book Page 989 Monday, October 3, 2011 11:05 AM