OSPF Commands 1137
•
seconds
— Sets the estimated number of seconds it takes to t ransmit a link
state update packet over this interface. (Range: 1–3600 seconds)
Default Configuration
1 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transit Delay for VLAN 15 at 20
seconds.
console(config-if-vlan15)#ip ospf transmit-delay 20
maximum-paths
Use the maximum-paths command in Router OSPF Configuration mode to
set the number of paths that OSPF can report for a given destination. Use the
no form of the command to reset the number to the default value.
Syntax
maximum-paths
integer
no maximum-paths
•
integer
— Number of paths that OSPF can report for a given destinat ion.
(Range: 1–4.)
Default Configuration
4 is the
integer
default value.
Command Mode
Router OSPF Configuration mode.
2CSPC4.XCT-SWUM2XX1.book Page 1137 Monday, October 3, 2011 11:05 AM