Dell prefix-length, service, priority-value

1418 Management ACL Commands
• gigabitethernet unit/slot/port — A valid 1-gigabit Ethernet-routed port
number.
•
vlan vlan-id — A valid VLAN number.
•
port-channel port-channel-number — A valid port channel number.
•
tengigabitethernet unit/slot/port — A valid 10-gigabit Ethernet-routed
port number.
•
ip-address — Source IP address.
•
mask mask — Specifies the network mask of the source IP address.
•
mask prefix-length — Specifies the number of bits that comprise the
source IP address prefix. The prefix length must be preceded by a forward
slash (/). (Range: 0–32)
•
service service — Indicates service type. Can be one of the following:
telnet , ssh , http , https , tftp , snmp , sntp , or any . The any keyword indicates
that the service match for the ACL is effectively "don’t care".
•
priority priority-value — Priority for the rule. (Range: 1 – 64)
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with gigabitethern et, tengigabitethernet, vlan, and port-channel
parameters are valid only if an IP address is defined on the appropriate
interface. Ensure that each rule has a unique priority.
Examples
The following example shows how to configure two management interfaces,
gigabit Ethernet 1/0/1 and gigabit Ethernet 2/0/9.
console(config)#management access-list mlist
console(config-macal)# permit gigabitethernet 1/0/1 priority 1
console(config-macal)# permit gigabitethernet 2/0/9 priority 1
console(config-macal)# exit
2CSPC4.XCT-SWUM2XX1.book Page 1418 Monday, October 3, 2011 11:05 AM