1404 Denial of Service Commands
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan10)#ip redirects
ipv6 icmp error-interval
Use the icmp error-interval command to limit the rate at which ICMP error
messages are sent. The rate limit is configured as a token bucket with two
configurable parameters: Burst-size and burst interval. Use the no form of this
command to return burst-interval and burst-size to their default values. To
disable ICMP rate limiting, set burst-interval to zero.
Syntax
ipv6 icmp error-interval

burst-interval

[

burst-size

]
no ipv6 icmp error-interval
•

burst-interval

— How often the token bucket is initialized (Range:
0–2147483647 milliseconds).
•

burst-size

— The maximum number of messages that can be sent during a
burst interval (Range: 1–200).
Default Configuration
Rate limiting is enabled by default.
The default burst-interval is 1000 milliseconds.
The default burst-size is 100 messages.
Command Mode
Global Configuration mode
2CSPC4.XCT-SWUM2XX1.book Page 1404 Monday, October 3, 2011 11:05 AM