1116 OSPF Commands
no area
area-id
virtual-link
neighbor-id
hello-interval
•
area-id
— Identifies the OSPF area to configure. (Range: IP address or
decimal from 0–4294967295)
•
neighbor-id
— Identifies the Router ID of the neighbor.
•
seconds
— Number of seconds to wait before sending hello packets to the
OSPF virtual interface. (Range: 1–65535)
Default Configuration
10 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 50-second wait interval.
console(config-router)#area 10 virtual-link
192.168.2.2 hello-interval 50
area virtual-link retransmit-interval
Use the area virtual-link retransmit-inter val command in Router OSPF
Configuration mode to configure the retransmit interval for the OSPF virtual
interface on the virtual interface identified by the area ID and neighbor ID.
Use the no form of the command to return the retransmit interval to the
default value.
Syntax
area
area-id
virtual-link
neighbor-id
retransmit-interval
seconds
no area
area-id
virtual-link
neighbor-id
retransmit-interval
•
area-id
— Identifies the OSPF area to configure. (Range: IP address or
decimal from 0–4294967295)
2CSPC4.XCT-SWUM2XX1.book Page 1116 Monday, October 3, 2011 11:05 AM