Dell match ip dscp

QoS Commands 669
match ip dscp
Use the match ip dscp command in Class-Map Configuration mode to add to
the specified class definition a match condition based on the value of the IP
DiffServ Code Point (DSCP) field in a packet. This field is defined as the
high-order six bits of the Service Type octet in the IP header. The low-order
two bits are not checked.
Syntax
match ip dscp dscpval
• dscpval — Specifies an integer value or a keyword value for the DSCP
field. (Integer Range: 0–63) (Keyword Values:
af11 , af12 , af13 , af21 , af22 ,
af23 , af31 , af32 , af33 , af41 , af42 , af43 , be , cs0 , cs1 , cs2 , cs3 , cs4 , cs5 , cs6 ,
cs7 , ef )
Default Configuration
This command has no default configuration.
Command Mode
Class-Map Configuration mode
User Guidelines
The ip dscp, ip precedence, and ip tos match conditions are alternative ways
to specify a match criterion for the same Service Type field in the IP header
but with a slightly different user notation.
To specify a match on all DSCP values, use the match ip tos
tosbits tosmask
command with tosbits set to "0" (zero) and tosmask set to hex "03."
Example
The following example displays how to add a match condition based on the
DSCP field.
console(config-classmap)# match ip dscp 3
2CSPC4.XCT-SWUM2XX1.book Page 669 Monday, October 3, 2011 11:05 AM