564 iSCSI Optimization Commands
The Application Priority TLV sent will contain the following information in
addition to any other information contained in the TLV:
AE Selector= 1
AE Protocol= 32 60
AE Priority= priority configured for iSCSI PFC (the VPT value above)
Example
In the following example, iSCSI is globally enabled.
console(config)#iscsi enable
iscsi target port
Use the iscsi target port command in Global Configuration mode to
configure iSCSI port(s), target addresses and names. To delete iSCSI port(s)
or target ports, use the no form of this command.
Syntax
iscsi target port

tcp-port-1

[

tcp-port-2.… tcp-port-16

[address
ip-address
]
[name

targetname

]
no iscsi target port

tcp-port-1

[

tcp-port-2.… tcp-port-16

[address
ip-address
]
Parameter Description
Parameter Description
tcp-port
TCP port number or list of TCP port numbers on which iSCSI
target(s) listen to requests. Up to 16 TCP ports can be defined
in the system in one command or by using multiple commands.
ip-address
IP address of the iSCSI target. When the no form is used, and
the tcp port to be deleted is one bound to a specific IP address,
the address field must be present.
2CSPC4.XCT-SWUM2XX1.book Page 564 Monday, October 3, 2011 11:05 AM