OSPF Commands 1101
area default-cost (Router OSPF)
Use the area default-cost command in Router OSPF Configuration mode to
configure the advertised default cost for the stub area. Use the no form of the
command to return the cost to the default value.
Syntax
area
area-id
default-cost
integer
no area
area-id
default-cost
•
area-id
— Identifies the OSPF stub area to configure. (Range: IP address
or decimal from 0-4294967295)
•
integer
— The default cost for the stub area. (Range: 1–16777215)
area range (Router
OSPF)
distribute-list out nsf helper show ip ospf neighbor
area stub enable nsf helper strict-
lsa-checking
show ip ospf range
area stub no-
summary
exit-overflow-
interval
nsf restart-interval show ip ospf statistics
area virtual-link external-lsdb-limit passive-interface
default
show ip ospf stub table
area virtual-link
authentication
ip ospf area passive-interface show ip ospf virtual-
link
area virtual-link
dead-interval
ip ospf
authentication
redistribute show ip ospf virtual-
links brief
area virtual-link
hello-interval
ip ospf cost router-id timers spf
area virtual-link
retransmit-interval
ip ospf dead-
interval
router ospf
area virtual-link
transmit-delay
ip ospf hello-
interval
show ip ospf
auto-cost ip ospf mtu-i gnore show ip ospf abr
2CSPC4.XCT-SWUM2XX1.book Page 1101 Monday, October 3, 2011 11:05 AM