IPv6 Routing Commands 1025
ipv6 nd other-config-flag
Use the ipv6 nd other-config-flag command in Interface Configuration mode
to set the “other stateful configuration” flag in router advertisements sent
from the interface.
Syntax
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Default Configuration
False is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets to true the “other stateful configuration” flag in
router advertisements
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd other-config-flag
ipv6 nd prefix
Use the ipv6 nd prefix command to configure parameters associated with
prefixes that the router advertises in its router advertisements.
Syntax
ipv6 nd prefix
ipv6-prefix/prefix-length
[{valid-lifetime | infinite}
{preferred-lifetime | infinite}] [no-autoconfig] [off-link]
no ipv6 nd prefix
ipv6-prefix/prefix-length
2CSPC4.XCT-SWUM2XX1.book Page 1025 Monday, October 3, 2011 11:05 AM