Dell ip ospf cost, ip ospf dead-interval

OSPF Commands 1131
ip ospf cost
Use the ip ospf cost command in Interface Configuration mode to configure
the cost on an OSPF interface. Use the no form of the command to retu rn
the cost to the default value.
Syntax
ip ospf cost interface-cost
no ip ospf cost
• inte rface-cost — Specifies the cost (link-state metric) of the OSPF
interface. (Range: 1–65535)
Default Configuration
10 is the default link-state metric configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the cost on the OSPF interface at 5.
console(config-if-vlan15)#ip ospf cost 5
ip ospf dead-interval
Use the ip ospf dead-interval command in Interface Configuration to set the
OSPF dead interval for the specified interface. Use the no form of the
command to return the interval to the default value.
Syntax
ip ospf dead-interval seconds
no ip ospf dead-interval
2CSPC4.XCT-SWUM2XX1.book Page 1131 Monday, October 3, 2011 11:05 AM