1634 System Management Commands
User Guidelines
The clear config command will not change the stacking port mode. Only the
stack-port command can change the operating mode of the stacking port and
it only takes effect after a reboot when chang ing between stacking and
Ethernet mode. If this command is used with a CX-4 module, the ports will
be forced to Ethernet mode upon reboot.
Use the show switch stack-port command to display configuration and status
of stacking ports.
Use the show switch command to display informatio n regarding the switches
in a stack.
Example
console(config-stack)#stack-port tengigabitethernet
1/0/3 stack
console(config-stack)#
standby
Use the standby command to configure the standby in the stack. This unit
comes up as the master when the stack failover occurs. Use the no form of
this command to reset to default, in which case, a standby is automatically
selected from the existing stack units if there no preconfiguration.
Syntax
standby
unit
no standby
•
unit
— Valid unit number in the stack. (Range: 1–12 maximum. The range
is limited to the number of units available on the stack.)
Default Configuration
The default configuration is to allow the software to automatically select a
standby unit.
Command Mode
Stack Global Configuration
2CSPC4.XCT-SWUM2XX1.book Page 1634 Monday, October 3, 2011 11:05 AM