1054 IPv6 Routing Commands
show ipv6 route
Use the show ipv6 route command in User EXEC or Privileged EXEC mode
to display the IPv6 routing table. The output of the command also displays
the IPv6 address of the default gateway and the default route associated with
the gateway.
Syntax
show ipv6 route [ipv6-address | ipv6-prefix/prefix-length | protocol |
interface-type interface-number] [best]
Syntax Description
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes
User Guidelines
This command has no user guidelines.
Parameter Description
ipv6-address Specifies an IPv6 address for which the best-matching route
would be displayed.
protocol Specifies the protocol that installed the routes. Is one of the
following keywords: connected, ospf, static.
ipv6-prefix/ prefix-
length
Specifies an IPv6 network for which the matching route would
be displayed.
interface-type
interface-number
Valid IPv6 interface. Specifies that the routes with next-hops on
the selected interface be displayed. Supported interface types
are VLAN, Tunnel, and Loopback.
best Specifies that only the best routes are displayed. If the
connected keyword is selected for protocol, the best option is
not available because there are no best or non-best connected
routes.
2CSPC4.XCT-SWUM2XX1.book Page 1054 Monday, October 3, 2011 11:05 AM