Address Table Commands 295
console(config)# mac address-table vlan 8 multicast
static 0100.5e02.0203 add interface gigabitethernet
1/0/1-9, 1/0/2
mac address-table static
Use the mac address-table static command in Global Configuration mode to
add a static MAC-layer station source address to the bridge table. To delete
the MAC address, use the no form of the mac address-table static command.
Syntax
mac address-table static
mac-addr
vlan
vlan-id
interface {gigabitethernet |
port-channel | tengigabitethernet}
interface-id
no mac address-table static
mac-addr
vlan
vlan-id
[interface
{gigabitethernet | port-channel | tengigabitethernet}

interface-id]

Syntax Description
Default Configuration
No static addresses are defined. The default mode for an added address is
permanent.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Parameter Description
mac-address
A valid MAC address in the format xxxx.xxxx.xxxx.
vlan-id
Valid VLAN ID (1-4093)
interface-id
A valid physical unit/slot/port or port-channel number.
2CSPC4.XCT-SWUM2XX1.book Page 295 Monday, October 3, 2011 11:05 AM