Ethernet Configuration Commands 429
User Guidelines
This command has no user guidelines.
Example
console(config-if-1/0/1)#storm-control broadcast
level 5
storm-control multicast
Use the storm-control multicast command in Interface Configuration mode
to enable multicast storm recovery mode for an interface. If the mode is
enabled, multicast storm recovery is active, and if the rate of L2 multicast
traffic ingressing on an interface increases beyond the configured threshold,
the traffic will be dropped. Therefore, the rate of multicast traffic will be
limited to the configured threshold.
When you use the no storm-control multicast command to "disable" storm-
control after having set the level or rate to a non-default value, that value is
still set but is not active until you re-enable storm-control.
Syntax
storm-control multicast [level |
rate
]
no storm-control multicast
• level— The configured rate as a percentage of link-speed.
•
rate
— The configured rate in kilobits per second (kbps). (Range: 0-100)
Default Configuration
The default value is 5.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
2CSPC4.XCT-SWUM2XX1.book Page 429 Monday, October 3, 2011 11:05 AM