1176 OSPFv3 Commands
area default-cost (Router OSPFv3)
Use the area default-cost command in Router OSPFv3 Configuration mode
to configure the monetary default cost for the stub area. The operator must
specify the area id and an integer value between 1-16777215. Use the no form
of the command to return the cost to the default value. If the area has not
been previously created, this command creates the area and then applies the
default-cost.
Syntax
area
area-id
default-cost
cost
no area
area-id
default-cost
•
areaid
— Valid area identifier.
•

cost

— Default cost. (Range: 1-16777215)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the monetary default cost at 100 for stub
area 1.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 default-cost 100
area virtual-link
retransmit-interval
ipv6 ospf network show ipv6 ospf show ipv6 ospf virtual-
link brief
2CSPC4.XCT-SWUM2XX1.book Page 1176 Monday, October 3, 2011 11:05 AM