Using the CLI 173
Table 2-4. Interface Identifiers
When listed in command line output, gigabit Ethernet interfaces are
preceded by the characters
Gi
, and ten-gigabit Ethernet interfaces are
preceded by
Te
, as shown in the examples below.
Port Channel Interfaces
Port-channel (or LAG) interfaces are represented in the CLI by the variable
port-channel-number
., which can can assume values from 1-48.
When listed in command line output, port channel interfaces are preceded by
the characters
Po
.
Loopback Interfaces
Loopback interfaces are represented in the CLI by the variable
loopback-id
,
which can assume values from 0–7.
VLAN Interfaces
VLAN interfaces are represented in the CLI by the variable
vlan-id
, which
can can assume values from 1-4093.
Tunnel Interfaces
Tunnel interfaces are represented in the CLI by the variable
tunnel-id
, which
can can assume values from 0–7.
Interface Type Long Form Short Form Identifier
Fast Ethernet fast ethernet fa unit/slot/port
Gigabit Ethernet gigabitethernet gi unit/slot/port
10-Gigabit
Ethernet
tengigabitethernet te unit/slot/port
Loopback loopback lo loopback-id (0-7)
Port Channel port-channel po port-channel-number
Tunnel tunnel tu tunnel-id (0-7)
Vlan vlan vl vlan-id (1-4093)
2CSPC4.XCT-SWUM2XX1.book Page 173 Monday, October 3, 2011 11:05 AM