Port Channel Commands 633
lacp timeout
Use the lacp timeout command in Interface Configuration mode to assign an
administrative LACP timeout. To reset the default administrative LACP
timeout, use the no form of this command.
Syntax
lacp timeout {long | short}
no lacp timeout
•
long
— Specifies a long timeout value.
•
short
— Specifies a short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example assigns an administrative LACP timeout for port 1/0/8
to a long timeout value.
console(config)#interface gigabitethernet 1/0/8
console(config-if-1/0/8)#lacp timeout long
port-channel min-links
Use the port-channel min-links command in Interface Configuration (port-
channel) mode to set the minimum number of links that must be up in order
for the port channel interface to be declared up. Use the no form of the
command to return the configuration to the default value (1).
2CSPC4.XCT-SWUM2XX1.book Page 633 Monday, October 3, 2011 11:05 AM