Delta DVP-ES2/EX2/SS2/SA2/SX2/SE manual Ed H, Cb H

3. Instruction Set

Registers for data to be sent (sending messages)

	Register	Data		Descriptions
	D1256 下	01 H	Address
	D1257 下	0F H	Function
	D1258 下	05 H	Data Address
	D1259 下	00 H
	D1260 下	00 H	Number of Data(count by bit)
	D1261 下	10 H
	D1262 下	02 H	Byte Count
	D1263 下	34 H	Data content 1		Content of D0: H34
	D1264 下	12 H	Data content 2		Content of D1: H12
	D1265 下	21 H	CRC CHK Low
	D1266 下	ED H	CRC CHK High
Registers for received data (responding messages)

		Register	Data	Descriptions
		D1070 下	01 H	Address
		D1071 下	0F H	Function
		D1072 下	05 H	Data Address
		D1073 下	00 H
		D1074 下	00 H	Number of Data(count by bit)
		D1075 下	10H
		D1076 下	54H	CRC CHK Low
		D1077 下	CB H	CRC CHK High
Program example 10: COM1 (RS-232) / COM3 (RS-485), Function Code H0F
1.	Function code K15 (H0F): write in multiple bit devices. Up to 64 bits can be written
2.	PLC1 connects to PLC2: (M1143 = OFF, ASCII mode), (M1143 = ON, RTU mode)
3.	PLC COM1/COM3 will not process the received data.
4.	Take the connection between PLC1 (PLC COM3) and PLC2 (PLC COM1) for example, the

tables below explain the status when PLC1 force ON/OFF Y0~Y17 of PLC2. Set value: K4Y0=1234H

Device	Status	Device	Status	Device	Status	Device	Status
Y0	OFF	Y1	OFF	Y2	ON	Y3	OFF
Y4	ON	Y5	ON	Y6	OFF	Y7	OFF
Y10	OFF	Y11	ON	Y12	OFF	Y13	OFF
Y14	ON	Y15	OFF	Y16	OFF	Y17	OFF

z If PLC applies COM1 for communication, the below program can be usable by changing: 1. D1109→D1036: communication protocol

2. M1136→M1138: retain communication setting

3 - 3 5 3