Delta DVP-ES2/EX2/SS2/SA2/SX2/SE manual Reset after CH0 Y0, Y1 pulse output is completed

	3. Instruction Set
	reset after CH0 (Y0, Y1) pulse output is completed.
M1524	Auto-reset CH1 (Y2, Y3) when high speed pulse output completed. M524 will be
	reset after CH1 (Y2, Y3) pulse output is completed.
M1534	Enable ramp-down time setting on Y0. Has to be used with D1348
M1535	Enable ramp-down time setting on Y2. Has to be used with D1349
2. Special registers:
D1026:	Pulse number for masking Y0 when M1156 = ON (Low word). The function is
	disabled when set value≦0. (Default = 0 )
D1027:	Pulse number for masking Y0 when M1156 = ON (High word). The function is
	disabled when set value≦0. (Default = 0 )
D1135:	Pulse number for masking Y2 when M1156 = ON (Low word). The function is
	disabled when set value≦0. (Default = 0 )
D1136:	Pulse number for masking Y2 when M1156 = ON (High word). The function is
	disabled when set value≦0. (Default = 0 )
D1030:	Low word of the present value of CH0 (Y0, Y1) pulse output
D1031:	High word of the present value of CH0 (Y0, Y1) pulse output
D1131:	Input/output percentage value of CH0 (Y0, Y1) close loop control. Default: K100
D1132:	Input/output percentage value of CH1 (Y2, Y3) close loop control. Default: K100
D1244:	Idle time (pulse number) setting of CH0 (Y0, Y1) The function is disabled if set
	value≦0.
D1245:	Idle time (pulse number) setting of CH2 (Y2, Y3) The function is disabled if set
	value≦0.
D1336:	Low word of the present value of CH1 (Y2, Y3) pulse output
D1337:	High word of the present value of CH1 (Y2, Y3) pulse output
D1340:	Start/end frequency of the 1st group pulse output CH0 (Y0, Y1). Default: K100
D1352:	Start/end frequency of the 2st group pulse output CH1 (Y2, Y3). Default: K100
D1343:	Ramp up/down time of the 1st group pulse output CH0 (Y0, Y1). Default: K100
D1353:	Ramp up/down time of the 2nd group pulse output CH1 (Y2, Y3). Default: K100
D1348:	CH0(Y0, Y1) pulse output. When M1534 = ON, D1348 stores the ramp-down
	time. Default: K100
D1349:	CH1(Y2, Y3) pulse output. When M1535 = ON, D1349 stores the ramp-down
	time. Default: K100

3 - 4 4 5