Delta DVP-ES2/EX2/SS2/SA2/SX2/SE manual Programming Concepts

					2. Programming Concepts
M1002
	MOV	K17	D1121	Master ID#
	MOV	H86	D1120	COM2 communication protocol
	SET	M1120	Retain communication protocol
	MOV	K16	D1434	Data length to be read from Slave ID#1
	MOV	K16	D1450	Data length to be written into Slave ID#1
	MOV	K16	D1435	Data length to be read from Slave ID#2
	MOV	K16	D1451	Data length to be written into Slave ID#2
X1		Auto mode
	M1351
	M1350
	END

b)When X1 = On, the data exchange between Master and the two Slaves will be automatically executed by PLC LINK. The data in D100 ~ D115 in the two Slaves will be read into D1480 ~ D1495 and D1512 ~ D1527 of the Master, and the data in D1496 ~ D1511 and D1528 ~ D1543 will be written into D200 ~ D215 of the two Slaves.

Master PLC *1

D1480 ~ D1495

D1496 ~ D1511

D1512 ~ D1527

D1528 ~ D1543

Read

Write

Read

Write

Slave PLC*2

D100 ~ D115 of Slave ID#1

D200 ~ D215 of Slave ID#1

D100 ~ D115 of Slave ID#2

D200 ~ D215 of Slave ID#2

c)Assume the data in registers for data exchange before enabling PLC LINK (M1350 = OFF) is as below:

Master PLC	Preset value	Slave PLC	Preset value
D1480 ~ D1495	K0	D100 ~ D115 of Slave ID#1	K5,000
D1496 ~ D1511	K1,000	D200 ~ D215 of Slave ID#1	K0
D1512 ~ D1527	K0	D100 ~ D115 of Slave ID#2	K6,000
D1528 ~ D1543	K2,000	D200 ~ D215 of Slave ID#2	K0

After PLC LINK is enabled (M1350 = ON), the data in registers for data exchange becomes:

2 - 81