DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115 Issue 1
April 2000
G3vs with Intel 386 or Risc Processor to R8r
4-7Remove the Present System
4
Remove the Present System
■If the equipment room is large en ough to allow the Release 8r cabinet to
be installed while the present s ystem is in service, skip to ‘‘Install the
Release 8r Cabinets’’ on page 4-11. Return to this section when finished .
■If the present system must be removed to ma ke room for the Release 8r
cabinet, perform the following.

Save Translations and Announcements

1. Log in at the management terminal on t he present system.
2. Type save translation an d pr ess Enter. This command instructs the system
to write all translation information from memory to the translation c ard.
3. Check for translation errors before proc eeding with the up grade. If errors
are detected, refer to ‘‘No Translations After Upgrade’’ in Appendix B,
‘‘Troubleshooting an Upgrade’’ to correct the p roblem. Do not continue
with the upgrade until the e rrors are corrected.
4. If the system contains a TN750/B Announcement c ircuit pack, type
display announcements and press Enter .
NOTE:
The TN750C Announcement circuit pac k contains non-volatile
memory and does not requi re backup.
5. If administered recorded announcements are listed, typ e save
announcements and press Enter.
6. Remove the translation card and install the b ackup translation c ard.
Check Link Status
1. Type display communication-interface links and press Enter. Write down
all enabled links.
2. Type status link
number
and press Ente r. Repeat this step for all links.
3. Write down which links are in service.