DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115 Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-51Add IP Interface Assembly
6
Figure 6-22. TN802B IP Interface faceplate
NOTE:
If replacing the existing TN799 circuit pack, remove it first an d replace it
with the new one.
1. Insert the TN799B circuit pac k into the port slot identified earlier.
NOTE:
To properly seat the circuit pack, p ush firmly on the front of the
faceplate until the latch reac hes the bottom rail of the carrier. Then
close the latch until it is fully eng aged.
Figure Notes
1. LCD display
2. Reset button (recessed)
3. Red board status LED
4. PCMCIA card slot
5. Yellow PCMCIA disk-in-use LED
1
2
3
4
5
fpdfmapd KLC 030899