DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115 Issue 1
April 2000
Fiber Link Administration
A-6Administer Fiber Links
A
d. The DS1CONV Board Type: field is display only an d shows the
type of DS1 Converter circuit pac k in Endpoint-1. The circuit p ack
type in Endpoint-1 (A-PNC) and Endp oint-1 (B-PNC) must match.
e. In the Is one endpoint remoted via a DS1 Converter
Complex? field, type y to spec ify that a DS1 Converter complex is
used to remote 1 endpoint. If y is entered , administer the A-PNC
DS1 Converter Board Location on Page 1. The A-PNC DS1
Converter Board Type displays.
7. On Page 2 of the form:
a. Administer the A-PNC DS1 Converter (DS1CONV) Attributes.
b. Enter the DS1 Converter Facilities information. In the Facility
Installed? field, type y for all installed fac ilities (A, B, C, and D).
c. In the Bit Rate: field, typ e 1.544 for T1 operation or 2.048 for E1
operation.
NOTE:
One bit rate applies for all facilities within the same DS1
Converter complex. The Bit Rate: field d isplays only under
Facility A.
d. Enter the idle cod e in the Idle Code MSB (1) . . . . LSB
(8): field. The default value is 11101000. It is recommended that
the default value be used u nless it becomes absolutely necessary
to change it. The “MSB” means Most Signi ficant Bit, the “LSB”
means Least Significant Bit.
e. Enter the appropriate d ata in the Line Coding: field. This data
should match the line cod ing of the facility. For T1, example line
coding is b8zs. For E1, example line coding is hdb3.
f. Scroll to Page 3 and modify the fields as needed for the B-PNC.
NOTE:
If this data is not correct, wid eband errors (such as
multimedia call handl ing) may occur.
8. For T1 sites, refer to ‘‘T1 Installations Only’’. For E1 sites, refer to ‘‘E1
Installations Only’’.