DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115 Issue 1
April 2000
G3vs with Intel 386 or Risc Processor to R8r
4-11Install the Release 8r Cabinets
4
Install the Release 8r Cabinets

Unpack and Install the Release 8r Cabinet

1. Refer to the installation instructions in

DEFINITY Enterprise

Communications Server Release 8 Installation and Test for Multicarrier

Cabinets
.
!CAUTION:

Do not power up the Release 8r system.

2. Return to this section when the installation of the Release 8r is comp leted.

Remove Emergency Transfer Ground Wire

1. If the Release 8r is being installed while the present system is in service:
a. Connect a 10 AWG (#25) (2.6 mm2) wire either to pin 49 of the
connecting b lock or to pin 49 of the CAP (cabl e access panel)
associated with the emergen cy transfer panel.
b. Route the other end of the wire to an app roved ground and
connect.
2. If the present system was removed to make room for the Release 8r
cabinet:
a. Disconnect the 10 AWG (#25) (2.6 mm2) wire (installed earlier) from
the connecting b lock or pin 49 of the CAP (cab le access panel).

Power-Up the Release 8r

1. Insert the new Release 8r removable media into the op tical drive.
2. Power up the Release 8r cabinet and allow the syste m to boot up
completely.

List Configuration Software Long

1. Type list configuration software long and press Enter to verify the
removable media contains the req uired Release 8 software.
2. Make note of the entire alphanumeric string of the software version. This
information is used later.