DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115 Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-38Remove an EPN Cabinet from an Existing System
6
c. In the DS1CONV Board Location: field, remove the cabinet,
carrier, and slot that identi fies the physical locati on of DS1
Converter circuit pac k in the first endpoint of the duplicate fib er link.
Endpoint-1’s duplic ate along with Endpoint-2’s duplicate make up
the duplicate fib er link called the B-PNC link.
d. The DS1CONV Board Type: field is a display only field.
e. The Is one endpoint remoted via a DS1 Converter
Complex? field must remain administered if other fiber connections
associated with the facility will remain.
3. Scroll to screen 2.
a. Remove the DS 1 Conv erter Facilities information. In the Facility
Installed? field, type no for all facilities ( A, B, C, and D) to be
removed.
b. The Bit Rate: field must remain administered.
c. The idle code in the Idle Code MSB (1) . . . . LSB (8):
field must remain administered.
d. The data in the Line Coding: field must remain administered.
4. For a T1 site, proceed to ‘‘T1 Installations Only’’. For an E1 site, proceed to
‘‘E1 Installations Only’’.
T1 Installations Only
1. The Framing Mode: field is display only.
2. The DS1CONV-1 Line Compensation: and the DS1CONV-2 Line
Compensation: fields are display only.
3. Remove the Facility Circuit ID information from the facilities being
unadministered, if used. Press Ent er.
4. A display similar to the following ap pears after the proced ure is
completed:
RESET PORT-NETWORK 2 LEVEL 2 (COLD) PERFORMED.
E1 Installations Only
1. The CRC? field must remain administered.
2. The Line Termination: field is display only.
3. Remove the Facility Circuit ID information from facilities being
unadministered, if used. Press Ent er.
4. A display similar to the following ap pears after the proced ure is
completed:
RESET PORT-NETWORK 2 LEVEL 2 (COLD) PERFORMED.