DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115 Issue 1
April 2000
G3vs with Intel 386 or Risc Processor to R8r
4-9Remove the Present System
4
Shut Down DEFINITY AUDIX System
!WARNING:
Neglecting to shut d own an AUDIX assembly before powering d own the
system cabinet where it resides can damage the AUDIX disk.
1. If a DEFINITY AUDIX System resides in the system to be up graded, shut
down the AUDIX assembly and allow the d isk to completely spin down.
Refer to ‘‘DEFINITY AUDIX Power Procedures’’ on page 4-19.
2. Unseat the AUDIX assembly from its backp lane connectors.
Power Down Present System
!CAUTION:
Powering down the PPN will cause important system d ata, such as BCMS
data, records of qu eued ACD calls, Automatic Wakeup req uests, and Do
Not Disturb requests to be lost. Refer to DEFINITY Enterprise
Communications Server Release 8 Maintenance for R8r, for information
about preparing th e system for a power down.
1. At the PPN cabinet power supp ly, set the main circuit breaker to OFF.
Install Emergency Transfer Ground Wire
!CAUTION:
To avoid contaminating single-point g round, do not connec t the ground
strap while the system is powered up.
1. Connect a 10 AWG (#25) (2.6 mm2) wire either to pin 49 of the connecting
block or to pin 49 of the CAP (c able access p anel) associated with the
emergency transfer panel.
2. Route the other end of the wire to an approved ground and connec t.