DEFINITY Enterprise Communications Server Release 8.2
Upgrades and Additions for R8r
555-233-115 Issue 1
April 2000
Adding or Removing Cabinet Hardware
6-10Add the Fiber Optic Cable
6
Cabinet Preparation
1. Open the front door.
NOTE:
Administration may be requi red before removing the c ircuit pack in
the following step.
2. Determine which slot (1 or 2) will contain the new fiber optic circuit pack.
Remove the circuit pack or the b lanking plate from this slot.
NOTE:
If a circuit pack is removed from the required slot, it must be installed
into a different slot in the cabinet. All translations assoc iated with this
circuit pack mu st also be moved.
3. Remove the circuit pack or the b lanking plate from the slot next to the slot
determined in step 2 . Two consecutive open slots are required to install
the fiber optic ad apter.
NOTE:
If a circuit pack was removed in step 3, it will be rep laced into the
same slot, later in this section.
4. Install the new circuit pac k.
5. Open the rear door.
6. From the rear, remove the I/O cable connect or associated with the slot that
will contain the new fiber op tic circuit p ack. See Figure 6-2.