9
all
Beginning with IPSO 3.8, you can configure either a
Note
The HA mode applies only to
1.Click PIM under Configuration > Routing Configuration in the tree view.
2.In the PIM Instance Mode field, click On for sparse.
3.Click Apply.
4.In the HA Mode field, click On to enable the
5.Click Apply.
6.In the Interfaces section, click On for each interface to run PIM.
Note
The number of interfaces on which you can run PIM is unlimited
7.Click Apply.
8.(Optional) For each interface that is running PIM, enter the specified local address in the Local Address edit box. PIM uses this address to send advertisements on the interface. This option is useful only when multiple addresses are configured on the interface.
Note
If neighboring routers choose advertisement addresses that do not appear to be on a shared subnet, then all messages from the neighbor are rejected. A PIM router on a shared LAN must have at least one interface address with a subnet prefix that all neighboring PIM routers share.
9.(Optional) For each interface that is running PIM, enter a new designated router priority in the DR Election Priority text box. The router with the highest priority and the highest IP address is elected as the designated router. To break a tie, the designated router with the highest IP address is chosen. If even one router does not advertise a DR election priority value in its hello messages, DR election is based on the IP addresses. The default is 1, and the range is 0 to 4294967295 (2^32 - 1).
378 | Nokia Network Voyager for IPSO 4.0 Reference Guide |
