Note

By default, the update interval is set to 30 seconds and the expire interval is set to 180 seconds.

1.Click RIP under Configuration > Routing Configuration in the tree view.

2.To modify the update interval, enter the new update interval in the Update Interval text box; then click Apply.

3.To modify the expire interval enter the new expire interval in the Expire Interval text box; then click Apply.

4.To make your changes permanent, click Save.

Configuring Auto-Summarization

Auto-summarization allows you to aggregate and redistribute non-classful routes in RIP 1.

Note

Auto-summarization applies only to RIP 1.

1.Click RIP under Configuration > Routing Configuration in the tree view.

2.To enable auto-summarization, click on in the Auto-Summarization field; then click Apply.

3.To disable auto-summarization click off in the Auto-Summarization field; then click Apply.

4.To make your changes permanent, click Save.

Note

By default, auto-summarization is enabled.

RIP Example

Enabling RIP 1 on an Interface

RIP 1 is an interior gateway protocol that is most commonly used in small, homogeneous networks.

1.First configure the interface as in “Ethernet Interfaces.”

2.Click RIP under Configuration > Routing Configuration in the tree view.

3.Click on for the eth-s2p1c0 interface; then click Apply.

4.(Optional) Enter a new cost in the Metric edit box for the eth-s2p1c0 interface; then click Apply.

Nokia Network Voyager for IPSO 4.0 Reference Guide

369

Page 369
Image 369
Nokia IPSO 4.0 manual Configuring Auto-Summarization, RIP Example, Enabling RIP 1 on an Interface