Retry Limit specifies the number of times to retry InATMARP requests after which the Holdoff Timer is started. The range of Retry Limit value is 1 to 100 with a default value of 5.
Holdoff Time specifies time, in seconds, to hold off InATMARP requests after the maximum number of retries. The range of Holdoff Time value is 1 to 900 seconds (15 minutes), with a default value of 60 seconds (one minute).
3.Click Apply.
4.Click Save to make your changes permanent.
To add a static ATM ARP entry
1.Click Interfaces under Configuration > Interface Configuration in the tree view.
2.Click the logical ATM interface to configure in the Logical column.
3.Click the ATM ARP Entries link.
4.Enter the IP address of the new static ATM ARP entry in the IP Address field in the Create a new static ATM ARP entry section and enter the VPI/VCI number of the corresponding PVC in the VPI/VCI field.
The IP address must belong to the subnet of the logical ATM interface and the VCI must be one of those configured for the interface.
Note
Whenever static ATM ARP entries are applied, dynamic entries are no longer updated; therefore, new neighbors cannot be seen through a dynamic InATMARP mechanism.
5.Click Apply.
The newly created static ATM ARP entry appears in the Static ATM ARP Entries table. The IP datagrams destined to the IP address of the entry are sent to the PVC specified in the entry.
6.Click Save to make your changes permanent.
To delete a static ATM ARP entry
1.Click Interfaces under Configuration > Interface Configuration in the tree view.
2.Click the logical ATM interface to change in the Logical column.
3.Click the ATM ARP Entries link.
4.Click the Delete checkbox of the ATM ARP entry to delete. Click Apply.
5.Click Save to make your changes permanent.
To view and delete dynamic ATM ARP entries
1.Click Interfaces under Configuration > Interface Configuration in the tree view.
2.Click the logical ATM interface to configure in the Logical column.
Nokia Network Voyager for IPSO 4.0 Reference Guide | 131 |
