5
Sequence Verifier.
Worm Catcher
Delayed notification of connections
Security servers
IP pools (with
If any of the requirements for static work assignment apply to your cluster, you should use this setting. For example, you should use static work assignment if your cluster supports both of the following:
VPNs with Check Point gateways (static work assignment not required by this alone)
VPNs with
Configuring an Interface
To activate the cluster protocol, you must select at least two Ethernet interfaces. One of the two must be an internal or external interface (not a primary or secondary cluster interface). The other interface must be the primary interface.
Note
Nokia recommends that you select another interface as a secondary cluster protocol interface. Remember that the primary and secondary cluster protocol networks should not carry any production traffic.
The Interfaces Configuration table lists all the Ethernet interfaces on the system that are configured with IP addresses. The table displays the status and IP address of each interface. To add Ethernet interfaces to this list or to activate inactive interfaces, go to the Interface Configuration page.
To include an interface in the cluster
1.In the Select column, select Yes.
2.Enter the cluster IP address.
The address must be in the same network as the IP address of the interface you are configuring. This is a common IP address that each node will share.
3.Repeat the above steps for the rest of the interfaces that will participate in the cluster.
4.For the interface that will serve as the primary cluster protocol interface for the node, click the Yes button in the Primary Interface column.
The primary interfaces of all the cluster nodes must belong to the same network. This network should not carry any other traffic.
5.For the interface that will serve as the secondary cluster protocol interface for the node, click the Yes button in the Secondary Interface column.
222 | Nokia Network Voyager for IPSO 4.0 Reference Guide |
