Nokia IPSO 4.0 manual To configure a static route over an unnumbered interface

Note

Only point-to-point interfaces can be configured as unnumbered interfaces. Tunnels cannot be configured as unnumbered interfaces.

Note

This interface must not be the next hop of a static route.

3.Click No in the Unnumbered Interface field. Click Apply.

4.Click Save to make your change permanent.

Note

You must now configure a numbered logical interface.

To configure a static route over an unnumbered interface

1.Complete “To configure an unnumbered interface” for the interface.

1.Click Static Routes under Configuration > Routing in the tree view.

2.Enter the IP address of the destination network in the New Static Route text box.

3.Enter the mask length (in bits) in the Mask Length text box.

4.Select the type of next hop the static route will take from the Next Hop Type drop-down window. Your options are Normal, Reject, and Black Hole. The default is Normal.

5.Select Gateway Logical to specify the next-hop gateway type from the Gateway Type drop- down window.

Note

You select an unnumbered logical interface as the next-hop gateway when you do not know the IP address of the next-hop gateway.

6.Click Apply.

7.Click on the Gateway Logical drop-down window to view the list of unnumbered interfaces that are configured. Select the unnumbered logical interface to use as a next-hop gateway to the destination network.

8.Click Apply, and then click Save to make your change permanent.

Nokia Network Voyager for IPSO 4.0 Reference Guide 109