To configure a VLAN Interface
1.Click Interfaces under Interface Configuration in the tree view.
2.Click the link to the physical Ethernet interface for which you want to enable a VLAN interface.
The physical interface page for that interface is displayed.
3.Enter a value to identify the VLAN interface in the Create a new VLAN ID text box.
The range is 2 to 4094. The values 0 and 4095 are reserved by the IEEE standard. VLAN ID 1 is reserved by convention. There is no default.
4.Click Apply.
The new logical interface for the VLAN appears in the Logical Interfaces field with the name
5.Click Save to make your changes permanent.
Repeat steps 2 through 4 for each VLAN interface to create.
6.To assign an IP address to the new logical VLAN interface, click the link for the logical interface in the Interface field of the Logical Interfaces table. Enter the IP address in the New IP address text box. Enter the mask length in the New mask length text box.
7.Click Apply.
8.Click Save to make your changes permanent.
The new logical interface appears as active on the interface configuration page. Click Up to view that page.
(Optional) To disable the interface, click off in the Active field in the row for the logical interface.
9.Click Apply.
10.Click Save to make your change permanent.
Note
You can assign multiple IP addresses to each logical VLAN interface.
To delete a VLAN Interface
1.Click Interfaces under Configuration > Interface Configuration in the tree view.
2.Click the link for the physical interface for which to delete a VLAN interface in the Physical field.
This action takes you to the physical interface page for the interface.
3.In the Logical Interface table, click Delete in the row for the logical VLAN interface to delete.
4.Click Apply.
Nokia Network Voyager for IPSO 4.0 Reference Guide | 47 |