
Use E1 framing to select whether
7.Click On or Off for the E1
Note
This option appears only if you set the E1 Framing field to E1 (channel 0 framing).
This option chooses the framing format for
8.Click On or Off for the E1
Note
This option appears only if you set the E1 Framing field to E1 (channel 0 framing).
This option controls whether
9.Click Cisco HDLC in the Encapsulation field. Click Apply.
A logical interface appears in the Logical Interfaces table.
10.Enter a number in the Keepalive text box to configure the Cisco HDLC keepalive interval. Click Apply.
This value sets the interval, in seconds, between keepalive protocol message transmissions. These messages are used periodically to test for an active remote system. The range is 0- 255. The default is 10.
Note
This value must be identical to the keepalive value configured on the system at the other end of a
11.(Optional) Click the Advanced E1 CSU/DSU Options link to select advanced E1 options.
The E1 CSU/DSU Advanced Options page allows you to configure fractional E1 channels and other advanced settings for the E1 device. The values you enter on this page depend on the subscription provided by your service provider.
12.From the Advanced E1 CSU/DSU Options page, click Up to return to the physical interface page.
13.Click the logical interface name in the Interface column of the Logical Interfaces table to go to the Interface page.
Nokia Network Voyager for IPSO 4.0 Reference Guide | 97 |