Nokia IPSO 4.0 manual Nokia Network Voyager for Ipso 4.0 Reference Guide

2

17.In the To Remote Host section of the Authentication table, in the Password text box, enter the password to be returned to the remote host for PAP authentication, or the secret used to generate the challenge response for CHAP authentication.

Note

The To Remote Host information must be the same as the From Remote Host information (or its equivalent) at the remote end of the link.

18.In the From Remote Host section of the Authentication table select the authentication method used to authenticate the remote host.

19.In the From Remote Host section of the Authentication table, in the Name text box, enter the name that will be returned from the remote host when this host attempts to authenticate the remote host.

20.In the From Remote Host section of the Authentication table, in the Password text box, enter a password to be returned by the remote host for PAP authentication, or the secret used to validate the challenge response for CHAP authentication.

Note

The From Remote Host information must be the same as the To Remote Host information (or its equivalent) at the remote end of the link.

Note

The Bandwidth Allocation table entries that follow allow the network administrator to manage the parameters that are used to determine when to add or remove an additional B-channel only when using Multilink PPP.

21.In the Bandwidth Allocation table, in the Utilization Level text box, enter a percentage bandwidth use level at which the additional B-channel is added or removed.

When the measured use of an outgoing B-channel exceeds the utilization level threshold for a period greater than the use period, the second B-channel is brought into operation. When the outgoing B-channel use falls below the use level for a period greater than the value of the use period, the second B-channel is removed from operation.

A use level of zero means that the second B-channel is never brought into operation. To bring the second B-channel into operation quickly, set the use level to a low number, such as one.

22.In the Bandwidth Allocation table, in the Utilization Period text box, enter the use period.

This value specifies the number of seconds the outgoing B-channel use must remain above the use level before a second channel is brought into operation. When a second B-channel has been added, this value specifies the number of seconds that the use of the outgoing B- channel must be below the use level before the second B-channel is removed from operation.

54 Nokia Network Voyager for IPSO 4.0 Reference Guide