Nokia IPSO 4.0 manual 496

12

Note

If the message indicates that you have insufficient resources to accommodate a larger buffer size, take appropriate actions and try this procedure again. For further information, contact Nokia Technical Assistance Center (TAC).

4.After you verify that the change is appropriate, issue the same command without the -noption:

modzap _fw_log_bufsize $FWDIR/boot/modules/fwmod.o 0x200000

A confirmation message is displayed, which you can safely ignore.

5.Reboot the system.

Because these console messages are also written to the FW-1 log message file, Nokia recommends that you do the following to prevent depleting the disk space allocated for the FW-1 log message file:

1.Move your log files from the system hard drive to a server.

2.Configure the relocated files by using the Check Point management client GUI (Smart Dashboard) as follows:

a.Select the Check Point gateway object you are configuring.

b.Under Gateway Object Configuration, select the Logs and Masters section and do the following:

„Specify the amount of free disk space required for local logging.

„Specify to stop logging when the free disk space drops below x MB and to start logging to a new file.

Once a new file is being used, the previously used log files are deleted until the required free disk space is restored.

496 Nokia Network Voyager for IPSO 4.0 Reference Guide