FDDI Interfaces
To configure an FDDI Interface
1.Click Interfaces under Configuration > Interface Configuration in the tree view.
2.Click the physical interface link you want to configure in the Physical column. Example:
3.Click Full or Half in the Physical Configuration table Duplex field.
4.Click Apply.
Note
Set device attached to a ring topology to half duplex. If the device is running in
5.Click the logical interface name in the Interface column of the Logical Interfaces table to go to the Interface page.
6.Enter the IP address for the device in the New IP address text box.
7.Enter the subnet mask length in the New mask length text box. Click Apply.
Each time you click Apply, the configured IP address and mask length are added to the table. The entry fields remain blank to allow you to add more IP addresses.
To enter another IP address and IP subnet mask length, repeat steps 6 through 7.
8.(Optional) Change the interface’s logical name to a more meaningful one by typing the preferred name in the Logical name text box.
9.Click Apply.
10.(Optional) Add a comment to further define the logical interfaces function in the Comments text box.
Click Apply.
11.Click Up to go the Interface Configuration page.
12.Click On button that corresponds to the logical interface you configured. Click Apply.
The FDDI interface is now available for IP traffic and routing.
13.Click Save to make your changes permanent.
Nokia Network Voyager for IPSO 4.0 Reference Guide | 49 |
