2
10.Click the logical interface name in the Interface column of the Logical interfaces table. The Interface page appears.
11.Enter the IP address for the local end of the link in the Local address text box.
12.Enter the IP address of the remote end of the link in the Remote address text box. Click Apply.
13.(Optional) Change the interfaces logical name to a more meaningful name by typing the preferred name in the Logical name text box.
Click Apply.
14.(Optional) Add a comment to further define the logical interfaces function in the Comments text box.
Click Apply.
15.Click Save to make your changes permanent.
To configure a Serial Interface for PPP
1.Click Interfaces under Configuration > Interface Configuration in the tree view.
2.Click the physical interface link to configure in the Physical column. Example:
3.(Optional) Click On or Off in the Physical configuration table Internal Clock field to set the internal clock on the serial device.
Click Apply.
Set the internal clock to On when you are connecting to a device or system that does not provide a clock source. Otherwise, set the internal clock to Off.
4.If you turned the internal clock on, enter a value in the Internal clock speed text box.
If the device can generate only certain line rates, and the configured line rate is not one of these values, the device selects the next highest available line rate.
5.Click Full Duplex or Loopback in the Channel Mode field. Full duplex is the normal mode of operation.
6.Click the PPP radio button in the Encapsulation field.
7.Click Apply.
A logical interface appears in the Logical Interfaces table.
8.Enter a number in the Keepalive text box to configure the PPP keepalive interval.
This value sets the interval, in seconds, between keepalive protocol message transmissions. These messages are used periodically to test for an active remote system.
Note
This value must be identical to the keepalive value configured on the system at the other end of a
84 | Nokia Network Voyager for IPSO 4.0 Reference Guide |
